C Stamp Product Line


 HOME      PRODUCTS      ACCESSORIES      SENSORS      COMPONENTS      ROBOTICS      SUPPORT      FORUMS      CONTACT US             Toll-Free Sales: 1-800-985-AWIT


  PROD
UCTS
 
  C Stamp Products
  
C Stamp Accessories

   Integrated Circuits
    Amplifiers
    Data Conversion
    Digital Potentiometers
    EEPROM
    Interfaces
    Sensors
    Voltage Regulators
   Sensors
   Components
   Robotics
   Instruments and Tools
   Apparel
   Gift Certificates

   Educational Kits

   PCB Fabrication


  SUPPORT
   Discussion Forums

   Knowledge Database

   A-WIT Downloads
   EMail Technical Support
   Telephone Support  
  
  
Authorized Consultants



  KEY LINKS
   System Description
   Project Gallery
   Robotics Summer Camp
   Press Room
   Terms and Conditions
   Contact A-WIT
  
Privacy Policy

   Ordering Info
   Distributors
   Fun Zone

   SALES
 
 
 
Part#: CS451000
  Dual Operational Amplifiers
  Price:  $0.49

 

Dual Operational Amplifiers

 

DESCRIPTION: 
These devices consist of two independent, high-gain, frequency-compensated operational amplifiers designed to operate from a single supply over a wide range of voltages. Operation from split supplies also is possible if the difference between the two supplies is 3 V to 32 V, and VCC is at least 1.5 V more positive than the input common-mode voltage. The low supply-current drain is independent of the magnitude of the supply voltage. Applications include signal conditioning, transducer amplifiers, DC amplification blocks, and all the conventional operational amplifier circuits. These devices can be operated directly from the standard 5-V supply used in digital C Stamp
TM based systems and easily can provide required interface electronics without additional ±5-V supplies; thus the OPAMPs are compatible with the C Stamp microcomputer’s supplies and signal levels. The devices are supplied in an 8-pin DIP form factor package that can be used in breadboards or printed circuit boards. Interfacing with the OPAMPs is made easy with A-WIT's supplied software command ANALOGIN. This simple one commands interface is all that is required to read the output of an OPAMP via the analog to digital conversion capability of the C Stamp, and obtain a digital value of the analog voltage of interest for further digital based processing.

All items are new, fully tested, factory direct!

All software included at no extra charge!

Technical Specifications

  • Wide Supply Range
  • Single Supply . . . 3 V to 32 V or
  • Dual Supplies . . . ±1.5 V to ±16 V
  • Low Supply-Current Drain, Independent of Supply Voltage . . . 0.7 mA Typ
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground
  • Low Input Bias and Offset Parameters
  • Input Offset Voltage . . . 3 mV Typ
  • Input Offset Current . . . 2 nA Typ
  • Input Bias Current . . . 20 nA Typ
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage . . . 32 V
  • Open-Loop Differential Voltage Amplification . . . 100 V/mV Typ
  • Internal Frequency Compensation

Related Items
C Stamp 48-Pin Module
Piezo Speaker

Documentation
CS451000 Data Sheet


Do you need more information?

E-Mail us ... info@a-wit.com
 


Contact Us Terms of Use Privacy Policy
         
Home © A-WIT Technologies, Inc. All Rights Reserved. Return to Top