DESCRIPTION:
The CS454500 128 x 1 Linear Array With Hold consists of a 128 × 1 array of photodiodes, associated charge amplifier circuitry, and an internal pixel data-hold function that provides simultaneous-integration start and stop times for all pixels. The pixels measure 63.5 μm (H) by 55.5 μm (W) with 63.5-μm center-to-center spacing and 8-μm spacing between pixels. Operation is simplified by internal control logic that requires only a serial-input (SI) signal and a clock. All inputs and the output are compatible with the C Stamp microcomputer’s supplies and signal levels, allowing direct two-way communication with the microcontroller for control and output interface. Communicating with the device is made easy with A-WIT's supplied software commands STPIND and ANALOGIN. This simple two commands interface is all that is required to setup the device, and acquire the light readings from it.

All items are new, fully tested, factory direct!

All software included at no extra charge!

Technical Specifications

• 128 × 1 Sensor-Element Organization
• 400 Dots-Per-Inch (DPI) Sensor Pitch
• High Linearity and Uniformity
• Wide Dynamic Range . . . 4000:1 (72 dB)
• Output Referenced to Ground
• Low Image Lag . . . 0.5% Typ
• Operation to 8 MHz
• Single 3-V to 5-V Supply
• Rail-to-Rail Output Swing (AO)
• No External Load Resistor Required
• Communicates directly with the C Stamp microcontroller
• 8-pin DIP package
• Compact and breadboard-friendly
• Compatible with C Stamp microcomputer

Related Items
C Stamp 48-Pin Module

Documentation
CS454500 Data Sheet


Do you need more information?

E-Mail us ... info@a-wit.com